Investigating the Accuracy of the Air-column Length

Investigating the Accuracy of the Air- towboat Length1.0 Introduction (max viosterol words)Sound is a vibration that transmits as a typically clunky mechanical wafture of displacement and coerce through a mediocre such as wet or spread (Wikipedia, 2015). A pressure disturbance that travels through a sensitive (particle to particle interaction) is called a hard wave. Particles become disturbed, causing genius to exert a force to the attached particle accordingly particles are disturbed from rest resulting in free energy being transported through the medium (The Physics Classway, 1996-2015). The displacement of a mediums particles is parallel to the wave propagation direction, which characterises longitudinal wave (A.Russell D, 1998). Particles do not travel down the subway system they vibrate back and by between their individual equilibrium. Due to the longitudinal waves, there are particles in the transport that are compressed, whereas opposites are dispersed, which are called compression and rarefaction ( beneathframe 1). The longitudinal wave does not realisticize peaks, so the wave continuance is usually thrifty using the standoffishness between the compressions or the rarefactions. Figure 1 Compression and rarefaction (Geeks Unite, 2013)The speed of just is dep abateent on the temperature, which notify be generated from, where v is the speed of pop off and T is the temperature. However, in the experiment the amphetamine of well(p) waves is found by multiplying the wave distance and the cognise oftenness of tuning forks.Wavelength is described as the length of one cycle of the wave. When a system is driven by the intrinsic frequency, a resonance frequency occurs. However, the amount of wavelength sections toilet determine several natural frequencies through a column of glow in a tubing ( in Figure 2). When a tuning fork is held above the provide (Figure 2) while vibrating, if the tuning forks frequency aligns with the air column, air particles will be pushed by the tuning forks vibrations at a frequency which causes the vibration in the air column (Ping E, 2011).Figure 2 Example of the experiments setup (NASA, 2010) Figure 3 Resonance tube with closed and open end (NASA, 2010)Although compressions and rarefactions are in opposite directions, when they are reflected at the end of the closed tube (closed end is water) into the converse direction propagation of waves are produced. The wavelength is betd through the air column, because a tubes shortest resonance length is a reap of the wavelength (Figure 3). Resonance occurs at the greatest amplitude of the sound waves, hence, wavelength can be calculated as (Walding R et al, 2004). The fundamental frequency (first harmonized) has a customer (when displacement of the amplitude is zero) at the closed end of the air column and an antinode at the open end (Figure 3 left) (The Physics Class agency, 1996-2015). By alineing the tube, the tercet harmon ic will appear next as one vibrational node and two vibrational antinodes form the frequency of the harmonic (Figure 3 right). Even though the wavelength and frequency can be multiplied to set out the fastness of sound, they are not factors that will affect the velocity, which indicates the changes in wavelength whole results in an inverse impact of the frequency (The Physics Classroom, 1996-2015).4.0 Discussion4.1 psychoanalysisBy investigating the truth of the air-column length using resonance tubes in water, it was clear that the results were achieved with relatively risque accuracy when compared with the calculated air-column length when the room temperature was measured and assumed to be unvarying at hence the velocity of sound was. It was discovered that the resonance tubes diameter had an corroborative relationship with the length of air-column, which an change magnitude in tubes diameter results in a decrease in the air-column length. From disconcert 1, the air-col umn lengths for distributively tube at all frequency declined from 0.161m, 0.231m and 0.329m to 0.134m, 0.203m and 0.301m respectively as the diameter of tubes change magnitude from 0.0164m to 0.0865m ( identical trend in accede 2). As graphical record 1 showed to a greater extent explicitly through the decreasing linear trendlines at different frequencies, the confirmatory relationship between air-column length and tube diameter was justified. Moreover, the gradients of the trendlines were the end field of study that appeared to be between, which approximately corresponded with equations of the theoretical info and the formula of wavelength (), but for this experiment using end correction of 0.4 could be invalid as each set of entropy may put up its specific end correction, peradventure causing inaccuracies. The measured information seemed to contain relatively high accuracy (overlapped with the theoretical data) in contrast with the theoretical data (Table 2) in Graph 1. Therefore, the end correction and hypothesis were justified.As frequency is inversely comparative to wavelength, Graph 2 illustrated the inverse relationship between frequency and air-column length where all air-column lengths declined as the frequency grew. While the values were close to 1, the data plotted did not perfectly fit the trendlines, which indicated that some shifts were in the data (see 4.2 Evaluation). Due to tube B and C having analogous diameters (0.038m and 0.039m), and only iii decimal places were kept when sharp the air-column lengths, the trends were not presented distinctly as the other three tubes. If the results were kept in more decimal places, tube C would consecrate a shorter air-column length than tube B at continuous velocity of sound and frequency.Anomalies were expected and four were identified (highlighted in Table 7). Standard deviation was used to distinguish between the raw data. Results were seen as anomalies if they were not in the range of two standard deviations and average air-column length (). The highlighted data were believed to be one-off values as they appeared randomly, hence disregarded when calculating the average air-column length. The anomalies may have occurred due to parallax when interpreting the measurements from the measuring tape, which can be avoided in further experiments. Another reason may withal be mistaking overtones as resonance or missing points of resonance, and particles (e.g. polyvinyl chloride pipes debris/scraps) Overall, the data collected were relatively trustworthy and expected in the hypothesis, thus, justified the inverse relationships between air-column length and tube, as well as frequency and air-column. Therefore, the data proved that wavelength was inversely proportionate to frequency (The Physics Classroom, 1996-2015).4.2 EvaluationThe experiment was completed in one day with consistency. However, flaws were found between measured data and theoretical data. Table 3 sho wed the percentage error between measured and calculated (theoretical) air-column length. all(a) percentage errors were less than 1% (varied from 0.004% to 0.612%). Hence, the errors were insignificant and the measured results contained relatively high accuracy with precision. Theoretically, the velocity of sound should be the same at crossways all tubes at all frequencies as the temperature was kept constant however, the data varied between a range of and (Table 4). Percentage errors were negligible (all under 1% with highest value of 0.397%) which were calculated to compare with the theoretical velocity at () (Table 5). Propagation error of velocity of sound was also investigated by considering the error of apparatus, which was compared with the theoretical velocity. Since this error was less than, the error was considered to be insignificant that the measured data contained comparatively high accuracy thus, justified the experiment as a valid experiment. Graph 3 presented the average velocity calculated, the velocities of louver pipes differed from each other. Theoretically, an increasing trend in variance should present in Graph 3, but pipe B and C seems to have passing large variances (errors), hence disregarded. Thus, increasing trend only applies to pipe A, C and E. Evidently, pipe A had the smallest variance, which implied high precision hence, pipe A was considered to have the highest accuracy.Furthermore, random errors were made as the tuning fork may have been held incorrectly as hands were moving up and down to adjust the air-column, or pipes were not held completely perpendicular to the ground. The anomalies can be better by using an electronic ruler to collect air-column lengths to avoid parallax. When purpose the harmonics, overtones which relates to the third and fifth frequencies should be avoided. In addition, room temperature may be measured when collecting each trials data to calculate the speed of sound to ensure higher accuracy of t he air-column length. Due to the experiment being conducted in the classroom with all other experiments conducting at the same time, surrounding noise might be another reason for anomalies occurring hence the experiment should be completed in a quiet room to avoid resonance interference by other sounds. Furthermore, the experiment can be extended by using AFO (Audio Frequency Oscillator) that generates frequency (at indisputable level) and a speaker instead of tuning forks to alternate the frequency and water level to determine the air-column length (Gadani D.H, 2011).Resonance is used in real life history applications, usually for music instruments. Flutes can be estimated as cylindric tubes with two open ends, whereas a clarinet has a closed end which the air is blown from one end and resonance occurs (Walding R et al, 2004). Clarinets usually have frequency range between 125Hz to 2000Hz (Brown S, 1996-2012) with 15mm inner diameter (Fox S, 2000). Since clarinets frequency coul d be around 200Hz, theoretical equation (at 256Hz from Graph 1) was manipulated (Graph 4) to determine the air-column length of the clarinet. The fundamental harmonic is predicted to occur at 33cm however, at the third harmonic the result (99cm) almost matches with the real clarinet length of 94cm (Nave R, 2015). The length of clarinet must be an exact wavelength in order for the resonance to occur. Therefore, with a percentage error of 6.38% the prediction seems reasonable and appropriate, which justifies that the experiment can be extrapolated to real life application in the future.5.0 ConclusionWhen the velocity of sound was kept constant at a certain temperature, the resonance tubes inner diameters were measured with known frequencies written on tuning forks, the wavelength was calculated, hence the air-column length could be set(p) (). It was found that the air-column length had an indirect relationship with the frequency when velocity of sound was kept constant and an inverse relationship with the tubes diameters while both velocity of sound and frequency were maintained the same. This supported the hypothesis that frequencies would have similar impacts on the air-column as the decrease in frequency would lead to an increase in air-column length when diameter was unchanged.